DIY King Bed Frame with Storage – A platform bed frame is the simplest design available; which consists of a simple sheet of wood, low to the ground, on which the mattress can rest. Platform beds can be placed on shelves and drawers to create storage space, placed on pedestals to achieve a certain height or built with short legs to achieve both objectives. Plans for a standard matrimonial mattress can be used for a California king simply by changing dimensions of wood.
The first step is place a rectangle with the 80-inch beams as the sides and two 73-inch beams. Locate inside the 80-inch beams as the top and bottom edges. All beams should rest on narrow sides (2 inches) wide. Next is fix the rectangle shape with two screws per corner, drilling the screws through the face of an 80-inch beam and at the end of a 73-inch beam.
And then fit the remaining four 73-inch beams into the rectangular frame of DIY king bed frame with storage to form the ribs. These beams, also provided on their narrow sides, should be aligned parallel to the other 73-inch beams and spaced approximately 15 inches from each other and the frame terminated. After that, screw the four beams into place as did the original weft, using two screws per joint point.
Place the plywood sheet on the top of the frame so that the edges of the sheet are flush with the edges of the frame. Screw the plywood sheet into place with one screw per corner, drilled through the plywood and into the beams. Drill an additional screw in the center of each short side and two screws, spaced evenly, on each long side. And the last step of all is sand the flat surface of the plywood and the outer face of the rectangular frame. It will gives you special touch of DIY king bed frame with storage.